Semi-Riven Multicoloured Slate Tiled Kitchen Floor Cleaned and Sealed

Slate tiles do look incredible but like any natural stone you really need to maintain the sealer if you want them to stay that way. Unfortunately it’s usually the case that the sealer wears off overtime especially in the high foot traffic areas such as Kitchens and within a few years the tiles become dull with ingrained dirt.

This process happens so gradually it goes un-noticed until the floor becomes difficult to keep clean and a decision is made to have it sorted out. This was certainly the case with this Semi Riven Multicoloured Slate tiled kitchen floor at a house in the Berkshire village of Spencer’s Wood. The floor had been installed about fifteen years prior and over the years the Slate had become soiled to the point where domestic cleaners weren’t having any effect.

Slate Tiled Kitchen Floor Before Cleaning Spencers Wood Slate Tiled Kitchen Floor Before Cleaning Spencers Wood

Cleaning Dirty Slate Kitchen Tiles

To begin the restoration I soaked the tiles in a strong dilution of Tile Doctor Remove and Go and left it to dwell for about twenty minutes re-applying extra solution when it had dried. Remove and Go is our go to product for removing old coatings such as in this case sealers, although much of the old sealer had worn off it was still present in the less busy areas of the floor and to get an even final result I needed to ensure all of it was removed. Once the old sealer had started to weaken I agitated the product using a black pad fitted to a rotary buffing machine. The rotary pad struggles to reach into the recesses of the grout lines so I also made sure to scrub the solution into the grout with a grout brush.

Slate Tiled Kitchen Floor During Cleaning Spencers Wood Slate Tiled Kitchen Floor During Cleaning Spencers Wood

I suspect there were multiple layers of sealer on this floor that had been applied over the years as some areas were proving particularly stubborn. Something stronger was going to be needed particularly in the grout lines. So I applied Tile Doctor HBU remover; HBU stands for Heavy Build-Up and allowed this to dwell for thirty minutes while I cleaned other areas.

Once I was satisfied that the Slate and the Grout was clean and clear of old sealers I gave the whole floor a rinse with water using a wet extraction machine. One the soiled cleaning solutions were removed you could really see the difference that the combination of cleaning products had made.

Slate Tiled Kitchen Floor During Cleaning Spencers Wood

The final step in the cleaning process was to give the floor an Acid Wash using a mild solution of Grout Clean-up which removes any surface grout (aka grout smears) and other mineral deposits from the slate to ensure they true beauty of the stone will be visible. Once this was removed the whole floor was rinsed with water to remove any trace of product and then dried as much as possible. After a final inspection the floor was left overnight to dry off fully.

Slate Tiled Kitchen Floor During Cleaning Spencers Wood

Sealing Slate Kitchen Tiles

Returning to the property the next day, I ran some quick damp tests to check for any excess moisture that might have prevented me from sealing the floor. We will always do this as excess moisture can affect the sealer curing.

Slate Tiled Kitchen Floor During Sealing Spencers Wood

The customer was very happy with the clean and the floor was dry so we discussed sealer options to find out their preference for Matt or Satin finish. With the decision made to go with a Satin finish I began the application of the Tile Doctor Seal and Go which enhances the look of the stone with an aesthetically pleasing low-sheen finish, as well as providing on-going protection against ingrained dirt and staining.

Slate Tiled Kitchen Floor After Sealing Spencers Wood Slate Tiled Kitchen Floor After Sealing Spencers Wood

A total of five coats of Seal and Go were needed to seal the Slate tiles and as you can see from the photos the sealer really put the life back into the floor.
 
 
Source: Slate Floor Cleaning and Renovation Service in Berkshire

Old Slate Floor Renovation in Northamptonshire

The problems with not maintaining a natural stone floor properly are manifold. The build-up of ingrained dirt and muck is not just unhygienic, it also makes the stone appear dull and discoloured – and for many property owners, this can completely ruin the character of a room.

Here’s an example of a very dull and lacklustre Slate tiled floor at a small cottage in Little Harrowden, which is tiny village of less than 1,000 people situated roughly three miles north-west of Wellingborough in Northamptonshire. The owner was concerned that the poor condition of the floor was making the feel kitchen narrow and confined, and so she called me to help with brightening it up with a deep clean and seal. Achieving a sheen finish would help to reflect the natural light that comes into the room.

Slate Floor Before Cleaning in Little Harrowden Wellingborough

Cleaning a Dirty Slate Tiled Floor

I began the restoration by masking up the edges of the room and applying a clear silicon to the base boards of the kitchen units to prevent any water damage.

My choice of cleaner was Tile Doctor Oxy Gel, which is a strong alkaline-based gel cleaner. It’s like Tile Doctor Pro Clean, which is also alkaline-based, except it sticks to the tile due to its consistency and so it’s excellent for cleaning vertical surfaces such as bathroom walls. On this occasion, I wanted to use Oxy Gel to keep the amount of water I needed to use to a minimum. Since this was an old cottage there were a few damp issues that I wanted to avoid exacerbating.

I spread the Oxy Gel out evenly over half of the floor, before agitating it with rotary brushes. I allowed this to dwell for 10 minutes before adding a small amount of water and agitating the floor again, this time paying attention to the grout lines, which were very badly soiled. This process was subsequently carried out over the rest of the floor.

Slate Floor During Cleaning in Little Harrowden Wellingborough

I wet-vaxed each area after completion of the process and then wet-vaxed the entire floor again to neutralise the tiles and remove any remaining product. The floor was then left to dry overnight.

Sealing a Slate Tiled Floor

Returning to the property the following day, I took damp meter readings to see if the tiles were dry enough to be sealed. As I mentioned, the floor had some damp issues so this was important to check. I did, in fact, have to use a heat gun to finish drying a few damp areas of grout.

Once satisfied, I sealed the Slate with Tile Doctor Seal & Go Extra, which is a breathable water-based sealer, which is ideal in situations where no damp proof membrane is present or where there are damp issues. Once dry, the sealer provides an aesthetically pleasing light sheen finish.

Slate Floor During Sealing in Little Harrowden Wellingborough

As you can see from the photo below, the deep clean and fresh seal really helped to improve the patina of this Slate tiled floor, helping the entire kitchen feel brighter and more spacious. Another satisfied client!

Slate Floor After Cleaning and Sealing in Little Harrowden Wellingborough


 
 
Source: Slate Tile Cleaning and Restoration in Northamptonshire